lggasil.blogg.se - Mixtape pro

Mixtape pro install#
Mixtape pro pro#

Moving towards the “+” will speed the music up, while moving towards the “–” will slow it down.ġ9. Pitch Fader: This controls the speed of the music. Hold Shift and this button to activate Keylock.ġ8. Pitch Bend Up: Press and hold to momentarily increase the speed of the track. Hold Shift and this button to adjust the pitch range.ġ7. Pitch Bend Down: Press and hold to momentarily reduce the speed of the track. Crossfader: Controls the blend between the two decks.ġ6.

Channel Fader: Adjusts the volume of the individual channels in the software.ġ5. Cue/PFL: Sends pre-fader audio to the cue channel for headphone monitoring.ġ4. Turning the knob left and right will produce a lowpass filter and high-pass filter, respectively.ġ3. Filter: Adjusts the amount of the filter effect. Low EQ: Controls the bass frequencies for the individual channels.ġ2. Mid EQ: Controls the mid-range frequencies for the individual channels.ġ1. High EQ: Controls the treble frequencies for the individual channels.ġ0. Level: Adjusts the pre-fader, pre-EQ audio level of the corresponding channel.ĩ. Quickly double-press a Load button to assign the same track on both decks.Ĩ. Load: Press one of these buttons while a track is selected to assign it to Deck 1 or 2, respectively. Master Output LEDs: Displays the audio level going to the Master Output.ħ. Cue Gain: Adjusts the volume for headphone cueing.Ħ. Cue Mix: Adjusts the audio output to the headphones, mixing between the cue output and the master mix output.ĥ. Mic Gain: Adjusts the level for the microphone input.Ĥ. Use the Mic Gain knob to control the microphone volume.ģ. Items not listed under Introduction > Box Contents are sold separately.Ĭh is summed with the final output of the Master Gain to the Master Output.

(1) Any amplifiers, speakers, or output devices,.

When powering everything off, power off your devices in the following order:.

Open your software program and load music to the decks.

Mixtape pro install#

Locate the Serato DJ Lite installation card in the box to download and install the software.(2) any amplifiers, speakers, or output devices.When powering everything on, power on your devices in the following order:.

Mixtape pro pro#

Plug all devices into AC power and connect MixTrack Pro FX’s USB port to a computer’s USB port using the included USB cable.

Connect MixTrack Pro FX’s outputs to power amplifiers, tape decks, and/or other audio sources.

If using a microphone, connect it to MixTrack Pro FX’s microphone input.

Make sure all devices are turned off and all faders and gain knobs are set to “zero”.

Place MixTrack Pro FX on a flat, stable surface.For additional product support, visit /support. For the latest information about this product (system requirements, compatibility information, etc.) and product registration, visit.